the
button, until you see the "ICouNT" message displayed.
Press the
button to proceed. The screen will show a 6 digit number that
will usually be moving up or down.
To exit this function, press the
Internal test
This function turns on the full display. This is done to check its state, capacity,
resolution and device software version. In this mode, press and hold the
"ZERO" button for two seconds, the display will show all display items one
by one. Once the visualisation is done, it will return to regular working mode.
RS-232C DATA OUTPUT CONFIgURATION
The equipment has a standard data output and an additional data output.
To access the configuration settings, press the
the
button until you see the "UArt" message.
Press the
button to proceed. You will see the following options for data
transmission speed:
br 001 – 1200 bauds
br 002 – 2400 bauds
br 004 – 4800 bauds
br 009 – 9600 bauds
br 019 – 19200 bauds
br 038 – 38400 bauds
br 057 – 56800 bauds
br 058 – 115000 bauds
button and then press
.
button and then press
41