Stability Filter - Gram K3 Serie Manual De Utilización

Now "MEM 1" is going to appear. Press
Now you can set the empty memory slot to zero. Press the
seconds, and the display will show zero.
To avoid incorrect zero settings, it's recommended to go back to the previous
menu. When "MEM 0" appears, press the
change to "MEM 0-1". Press
To disable storage container mode and turn back to regular mode, press
and then press
button, "MEM 0" will appear. Press
and the "NrSt 0" message will appear. Press the
function to "1" and proceed. Press the

Stability Filter

You can increase the scale stability using filters. This is especially useful
in adverse environmental conditions, or when weighing unstable or heavy
objects.
To access the function, press the
Press the
to proceed. A digit will be shown to the right, according to the following values:
Filter 0 - Factory programming (for qualified personnel only)
Filter 1 - For stable environments (quick response)
Filter 2 - For not very stable environments (average response)
Filter 3 - For unstable environments (not very quick)
Filter 4 - For very unstable environments (slow)
Filter 5 - For highly unstable environments (very slow)
Filter 6 - For extreme environments
38
for 5 seconds, until the word "Units" appears. Press the
button until you see the "FiLTEr" message displayed. Press
and then
button and then
again to proceed and
to change to "1", then press
button to exit the menu.
button. The display will show "PLU XX".
to exit the menu.
button for 4
to exit the menu.
button to change the
to