Weight Test (Control +/-) - Gram K3 Serie Manual De Utilización

Keep the button pressed to access the memory database and retrieve a
positon. The display will show "CLU XX". XX is the memory slot.
Use the and buttons to increase or decrease the flashing digits
value. Use the and buttons to select the right or left digit.
Once the required memory slot is selected, press the button to confirm.
The scale is now set up using the selected memory slot.
You can now start counting pieces by placing them on the platform or into a
container. The container's tare must already be set up.

WEIgHT TEST (CONTROL +/-)

This is a useful function to separate groups of products by weight. It allows
you to discard products that are below a specific weight or exceed it.
The scale shows a bar with a left (negative) side, and a right (positive) side. The
centre indicates accepted products. It also indicates the operation outcome
through three colour lights on the display. When the sample is between the
established limits, the weight is visualised in green. If the sample's weight
exceeds these limits, its weight is shown in red and vice versa if it's below the
limit its weight is shown in yellow colour.
The graphic indicates if each product is within the acceptable preprogramed
deviation, if it isn't the scale will signal an audio warning. The additional
option of a relay card is available. It enables the connection of external
28