Beta URBAN 125 Manual Del Usuario página 99

1
Deactivation: the chronometer can be
stopped in the following way:
1) automatically, if the speed is = 0
If the speed is = 0, the chronometer
stops, even if it has been activated using
the button.
Resetting: The chronometer can be reset
by pressing and holding down the button
(> 5 sec).
Exit: to exit chronometer mode, press
and hold down the button for approx. 2
to 5 seconds.
If the chronometer is operating at the
moment of exiting, the abbreviation LAP
will be shown fl ashing, independently of
the function displayed.
If the speed is >0, the LAP function cannot
be accessed: pressing the button causes
the function displayed to change.
If the speed is >0, it is not possible to
exit the LAP function: pressing the button
causes the value indicated to be reset.
The datum is not stored permanently.
If the datum is higher than 23-59 (that is,
23h59'59"), the system resets the LAP
and then restarts the count.
Note: In the absence of mains
power, the LAP value is irretriev-
ably lost.
GB
19