Aj Key - Selecting The Working Mode; Ak Key - Choice Of Wire Diameter; Al Key - Choice Of The Support Material; Am Key - Selections For Displays An1 And An2 - Cebora 208.00 Manual De Istrucciones

CEBORA S.p.A.
4.2

AJ key - Selecting the working mode.

Selection blocked in "two-stage".
The mode selection is indicate by the lighting of the corresponding led.
Led S Two-stage (always lit).
Led T Four-stage (always off).
Led U Welding with three levels of current (always off).
4.3

AK key - Choice of wire diameter.

Operative in Parameter Selection Internal mode, or in Standard program mode, Pulsed arc program
mode and Manual mode, if the selected "program number" = 0 (zero).
Each time the key is pressed calls up a different program, selected from among those saved, that uses the
support material selected.
The selected wire diameter is indicated by the lighting of the corresponding led.
Led V1 0.8 mm;
Led V1 + V2 0.9 mm;
Led V2 1.0 mm;
Led V3 1.2 mm;
Led V4 1.6 mm.
NOTE: If a selected wire diamenter does not correspond to any saved program, the displays O and P
show the message no Prg.
4.4

AL key - Choice of the support material.

Operative in Parameter Selection Internal mode, or in Standard program mode, Pulsed arc program
mode and Manual mode, if the selected "program number" = 0 (zero).
Each time the key is pressed calls up a different program, selected from among those saved, that uses the
support material selected.
The selected support material is indicated by the lighting of the corresponding led.
Led W1 iron (FE).
Led W2 aluminium (AL).
Led W3 stainless steel (SS).
Led X special (SP) (shows the choice of other special wires).
NOTE: If a selected support material does not correspond to any saved program, the displays O and P
show the message no Prg.
4.5

AM key - Selections for displays AN1 and AN2.

4.6

AX key - Selections for displays AN1 and AN2.

Operative in Parameter Selection Internal mode, or in Standard program mode, Pulsed arc program
mode and Manual mode, if the selected "program number" = 0 (zero).
These make it possible to scroll through the values shown on displays AN1 and AN2, in Up/Down mode.
4.7

AH key - Choosing Accessory functions.

Always operative.
Each time the key is pressed it calls up a different Accessory Function.
The function selected is indicated by the lighting of the corresponding led, and its value is shown on the
displays AN1 and/or AN2.
In Parameter Selection Internal mode, Standard program mode, Pulsed arc program mode and
Manual mode, the value shown on displays AN1 and/or AN2 may be edited using the keys AM and AX.
NOTE: If 5 seconds elapse without one of the keys AH, AM or AX being pressed, the selection of the
Accessory Function shuts off, and the Control Panel returns to its previous status.
At this point the last values that were shown on the display AN1 and/or AN2 remain saved.
Only certain Accessory Functions may be managed via the Control Panel:
3.300.162-D
27
GB
04/03/2016