Ivoclar Vivadent Programat CS Manual De Instrucciones página 52

5.6 Settings / test programs
By pressing the "Settings" key (78), the Settings will be displayed
(indication of the last selected Settings).
The cursor keys (79, 80) are used to toggle between the possible
settings. This screen can be exited with the ESC key (71) or a
Program key (82, 83, ...).
5.6.1 Settings / Configuration
Settings Display
Contrast
Temperature mode
Language selection
User calibration
value
Volume
Beeper tune
Programming
Settings
Renaming
Time
Date
Short description
The contrast can be
General write
set by means of the
protection
+ or – keys
The + and – keys can
be used to switch
from °C to °F
Enables language
selection
Vacuum test
program
This program is
suitable to conduct
Heating muffle test
the temperature
program
calibration by means
of the ATK 2. The
furnace head opens
automatically if the
Enter key is pressed.
Now insert the
Key test
ATK 2 sample in the
intended hole (see
7.6 Temperature
calibration) and start
the program by
Cleaning program
means of the START
key.
The desired volume
can be set by means
of the + or – keys
Dehumidification
program
The tune can be set
by means of the + or
– keys
Enables the pro-
gramming of the
parameters of the
currently selected
program. *
* Some programs are protected with a code. If there will be necessary changes, you will be
informed about the corresponding code.
20
Display Short description
Enables the renaming
of the currently
selected program. *
Enables the renaming
of the materials.
The time can be
entered by using the
– / + keys
The date can be
selected by using the
– / + keys
Enables activation or
deactivation of the
general write
protection by means
of the '-/+' keys once
the user code has
been entered.
Allows to check the
vacuum quality of
the system
Allows to check the
heating muffle. The
result is shown in
graphical form after
the end of the
program
Allows to check the
keypad
The program is used
to clean the heating
muffle and the
insulation materials
by a heat process.
Permits the
dehumidification of
the furnace