Support To Stationary Engine - JF 40 MAXXIUM Manual Técnico De Operación

4.4- Support to stationary engine

This support can be for electric, diesel or gas engine. That one for diesel or gas engine is
larger.
See below assembly instructions of the support with electric engine.
1- Necessary components
1- Stand jack (rail).
2- Support to fix motor.
3- Motor support plates.
4- Lever to discharge or tighten the belts.
5- Lock pin to fasten the engine in that position where
the belts tension is that recommended.
6- Kit of bolts, nuts and washers.
7- Machine pulley: 3 grooves and
8- Electric motor
(see power specification on page 15).
Motor pulley (8a): 3 grooves and
3 belts kit (9):
B-94 to JF 40
B-92 to JF 50
B-89 to JF 60
Diesel and gasoline engines.
Engine pulley: 3 grooves and Ø 200/220 mm.
3 belts kit (9):
B-105 to JF 40
B-105 to JF 50
B-105 to JF 60
10- Belt cover.
* Switch (11) not included in all
configurations, consult a representative of JF
Máquinas for more information.
20
Ø 265 mm.
Ø 110 mm.
8
8a
11
1
7
9
10
2
3
6
5
4