Fein Slugger JME Holemaker III Serie Instrucciones De Uso página 14

OBJ_BUCH-0000000281-001.book Page 14 Tuesday, July 4, 2017 11:42 AM
en
14
Filling the dismounted coolant container
Fig. 4
Upper closing cap
(figure 4)
Pull the empty coolant container out of the
2.
drill stand housing of the magnetic core drill.
Unscrew the cap from the coolant container.
Only use a coolant-lubricant emulsion (oil in
water) as the cooling agent.
1.
Observe the manufacturer's instructions on
coolant.
Screw the cap onto the coolant container
again.
Insert the filled coolant container into the
holder on the drill stand housing intended for
this purpose.
3.
Coolant container
4.
5.