Festo CPX-FB11 Manual De Instrucciones página 15

1 User instructionsEnglish
The field bus node CPX-FB11 is intended exclusively for
the use of the CPX terminal as a slave on the DeviceNet.
The maximum values specified in the section "Technical
specifications" must be observed here. Detailed informa-
tion can be found in the manual for the field bus node
P.BE-CPX-FB11-... as well as in the CPX system manual
P.BE-CPX-SYS-... .
Warning
S Switch off the power supply before connecting or
disconnecting plugs (otherwise this could lead to
functional damage).
S Use only power units which guarantee reliable
isolation of the operating voltages as per IEC 742/
EN 60742/VDE 0551 with at least 4 kV isolation
resistance (Protected Extra Low Voltage PELV).
Switch power packs are permitted, providing they
guarantee reliable isolation in accordance with
EN 60950/VDE 0805.
S Connect an earth conductor of sufficient cross-
sectional area to the connection on the CPX terminal
marked with the earth symbol.
S The CPX field bus node for DeviceNet contains elec-
trostatically sensitive components. Do not therefore
touch any contacts. Observe the regulations for
handling electrostatically sensitive components.
Please note
Commission only a CPX terminal which has been fitted
and wired completely.
Festo CPX-FB11 0206NH English 15