Install The Blower - Broan Best WP29M Serie Manual Del Usaurio

13.INSTALL THE BLOWER

Refer to instructions included with blower.
Once the blower is installed, plug the blower cord (A) into the female receptacle
and the power supply cord (B) onto the male connector inside the hood.
Do not plug the two cords into each other.
14.REINSTALL THE PAN
Using a Phillips no. 2 or Robertson no. 2 screwdriver and the retaining screws,
reinstall the pan (previously removed in step 6) inside the hood (shaded part on
illustration beside).
15.REINSTALL GREASE DRIP RAIL(S) AND BAFFLE FILTERS
Reinstall grease drip rail(s) (1). The illustration beside shows how to reinsert the
grease drip rail(s) into the range hood.
Remove protective plastic film covering Evolutionary™ hybrid baffle filters before installing them.
Before reinstalling Evolutionary™ hybrid baffle filters, slide out the secondary micromesh filters from their back and remove all
protective plastic film.
15.1 D I
UCTED NSTALLATION
Slide in the secondary filters into each baffle filters before reinstalling them on the hood.
15.2 N -D I
ON UCTED NSTALLATION
Discard the secondary filters. Slide in the charcoal filters included in the non-duct kit. Reinstall the filters on the hood.
It is recommended to install side filters first and finish with
center one(s).
1. Insert one end of Evolutionary™ hybrid baffle filter into
the upper channel of the hood.
2. Raise the other end toward the inside of hood and insert
in the grease drip rail of the hood.
Replacement filters are available from your dealer. See label
inside hood for size and part number.
For charcoal filter replacement kit, see table on page 12.
(INTERIOR OR EXTERIOR BLOWER)
WARNING
!
:
:
HE0078
HD0181
CAUTION
1
HD0180
- 9 -
A B
R
ETAINING SCREWS LOCATION
HD0176
1
2