Ac Voltage Measurements - koban KMD-13 Instrucciones Operativas

KMD-13
AUTORANGING MULTIMETER

AC VOLTAGE MEASUREMENTS

WARNING: Risk of Electrocution. The probe tips may
not be long enough to contact the live parts inside some
240V outlets for appliances because the contacts are
recessed deep in the outlets. As a result, the reading
may show 0 volts when the outlet actually has voltage on
it. Make sure the probe tips are touching the metal
contacts inside the outlet before assuming that no
voltage is present.
CAUTION: Do not measure AC voltages if a motor on
the circuit is being switched ON or OFF. Large voltage
surges may occur that can damage the meter.
1. Set the function switch to the V AC position.
2. Insert the black test lead banana plug into the negative
(COM) jack and the red test lead banana plug into the
positive (V) jack.
3. Touch the test probe tips to the circuit under test.
4. Read the voltage in the display. The display will indicate
the proper decimal point, value and symbol (AC, V, etc.).
18 www.grupotemper.com