Description Of The Inputs And Outputs; Rf Input; Rs-232C Serial Port - Promax PRODIG-3 Manual Del Usaurio

USER'S MANUAL. PRODIG-3

6 DESCRIPTION OF THE INPUTS AND OUTPUTS

6.1

RF input

The RF input is through the RF
signal level should never exceed 130 dBµV.
6.2

RS-232C serial port

The PRODIG-3 incorporates an RS-232C serial port for diagnosis, setup and
calibration processes. The signals in this connector are described in Table 4.
PIN No. SIGNAL
1 Carrier detect
2 Data Receive (RxD)
3 Data Transmit (TxD)
4 Data Terminal Ready (DTR)
5 Ground (GND)
6 Data Set Ready (DSR)
7 Request to Send (RTS)
8 Clear to Send (CTS)
9 Ring Indicator
03/2008
5
4
3
2
1
Figure 38.- RS-232C connector. External view.
Table 4.- Description of the RS-232C connector.
[9] connector on the side panel. The peak
9
8
7
6
CHARACTERISTICS
(not connected)
(not connected)
(not connected)
(not connected)
Page 59