Control Function Test - Alliance Laundry Systems SF18VNV Instalación/Mantenimiento

Control Function Test

The machine should be cleaned after the
installation is complete. A function test should
then be executed on the unloaded machine:
1. Check the power supply for such
characteristics as correct voltage, phase,
and cycles to be certain they are correct
for the machine.
2. Open manual shut-off valves to the
machine.
3. Turn on electric power.
4. Check the door interlock before
starting operation:
a. Attempt to start the washer with the
door open. The washer should not start
with the door open.
b. Close the door without locking
it and attempt to start the washer.
The washer should not start with the
door unlocked.
Power Supply
F232060 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
c. Close the door and start a cycle.
Attempt to open the door while the
cycle is in progress. The door should
not open.
If the door lock and interlock are not
functioning properly, call a service
technician.
5. Select Cycle 01 by pressing key 0 and
key 1 on the keypad. Then press the
Start key.
6. Run a complete cycle, checking
operation of water inlet valves, drain,
and extract functions.
7. Rotation must be counterclockwise in
the spin step. If rotation is not
counterclockwise in the spin step,
disconnect power. A qualified electrician
must reverse any two leads between the AC
drive and the motor. See Figure 14.
AC Drive Connections
Figure 14
Installation
Motor
Leads
Main Drive
Motor
R080IE3A
31