Service And Repair - Leister Varimat V2 Instrucciones De Funcionamiento

Types of Leister VARIMAT V2
Article no. 137.821 VARIMAT V2, CEE plug
Article no. 138.982 VARIMAT V2, without plug
Article no. 138.108 VARIMAT V2, Schuko plug
Article no. 139.734 VARIMAT V2, Japan plug
Accessories
Only Leister accessories should be used
Article no. 139.048 Carrying case (included in scope of delivery)
Article no. 138.817 Wire brush (included in scope of delivery)
Article no. 132.429 Welding plate (included in scope of delivery)
Article no. 107.067 Additional weight
Article no. 113.995 Grip nozzle 30 mm
Article no. 113.600 Grip nozzle 40 mm
Article no. 110.714 Maintenance set
Training
• Leister Technologies AG and its authorised Service Centres offer free welding courses and training.
Informationen below www.leister.com.
Maintenance
• The air inlet on the hot-air blower (8) must be cleaned with a brush if soiled
• Clean welding nozzle (9) with wire brush (33)
• Check power supply cord (1) and plug for electrical and mechanical damages

Service and repair

• If the drive counter reaches 400 h or the blower counter reaches 2000 h, the message
«Maintenance servicing» will appear on the display the next time the main switch (3) is
switched on. This message is displayed for 10 seconds and cannot be skipped by the
controls (4).
• Repairs should only be carried out by authorised Leister Service Centres. They guarantee
a correct and reliable repair service within 24 hours, using original spare parts in
accordance with the circuit diagrams and spare parts lists.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of gua-
rantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
32
400 V~ / 5700 W
230 V~ / 4600 W
230 V~ / 4600 W
200 V~ / 4200 W