Service And Repair - Leister COMET Manual De Instrucciones

Accessories
• Only Leister accessories should be used.
Training
• Leister Technologies AG and its authorised Service Centres offer free welding courses and training.
Informationen below www.leister.com.
Maintenance
•
Clean the hot wedge (7) with a wire brush.
• Clean the drive and pressure roller (20/21) with a wire brush.
• Treat the chain (22) with a suitable spray as required.
• Check power supply cord (1) and plug for electrical and mechanical damage.

Service and repair

• The tool should be checked after a maximum of approx. 1000 hours running time by an authorised Ser-
vice Centre
• Repairs should only be carried out by authorised Leister Service Centres. They guarantee a correct and relia-
ble repair service within 24 hours, using original spare parts in accordance with the circuit diagrams and
spare parts lists.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of gua-
rantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
32