Service And Repair - Leister DRIVE Manual Del Usuario

Accessories
On ne doit utiliser que des accessoires Leister.
• Overlap welding nozzle
• Pressure roller
• Single supporting carrier, double supporting carrier
• Guide handle
• Hot air blower TRIAC AT
• Hot air blower TRIAC ST
Training
Leister Technologies AG and its authorised Service Centres offer free welding courses and training. Informa-
tionen below www.leister.com.
Maintenance
• Clean the overlap welding nozzle (16) with a wire brush.
• Check power supply cord (1), Power supply cord coupling (2) and connector as well as extension
cable for electrical and mechanical damage

Service and repair

• Have your Service Centre check the motor brushes after about 1,000 hours of operation.
• Repairs should only be carried out by authorised Leister Service Centres. They guarantee a correct and
reliable repair service within 24 hours, using original spare parts in accordance with the circuit diagrams
and spare parts lists.
Warranty
• For this tool, the guarantee or warranty rights granted by the relevant distributor/seller shall apply. In case of gu-
arantee or warranty claims any manufacturing or workmanship defects will either be repaired or replaced by the
distributor at its discretion. Warranty or guarantee rights have to be verified by an invoice or a delivery document.
Heating elements shall be excluded from warranty or guarantee.
• Additional guarantee or warranty claims shall be excluded, subject to mandatory provisions of law.
• Warranty or guarantee shall not apply to defects caused by normal wear and tear, overload or improper handling.
• Warranty or guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
16