Field Of Application; Type Of Installation; Technical Features - EB TECHNOLOGY START-S4XL Manual De Instrucciones

START-S4XL
1 Introduction
1.1 Safety precautions
Using the unit improperly and performing repairs or modifi cations personally will void the warranty. The producer
declines any responsibility for damages due to inappropriate use of the product and due to any use other than the
use the product was designed for. The producer declines any responsibility for consequential damages except
civil liability for the products.
Every programming and/or every maintenance service should be done by qualifi ed technicians.
1.2

Field of application

The START-S4XL control board is designed to move gates, overhead garage doors, rolling shutters and automatic
doors. It can be connected to an oleodinamic motor or to an electro-mechanical motor with a singlephase motor,
working on 230 Vac.
1.3

Type of installation

It is important to establish the "MACHINE" risks and the requirements of the fi nal user. In the photo the fi nal user
will fi x the number of accessories to be installed. In the scheme the couple of the photo-beams A OPEN it has no
eff ect while it inverts completely after closing. "FOTO A2" is the serial connection of the foto A or ALT connection.
Check the synchronisation of the photo-beams which avoid interferences
Application on swing gates
We recommend to install a STOP switch which stops immediatelly the gate. The switch has a normally close
contact which opens the contact when it is working. See Par. 2.7
1.4

Technical features

Dimensions
Weight
MAX power of single motor
MAX power of signal light
MAX absorption with clean contact
MAX absorption 24 Vac (clamps 18-19)
MAX absorption 12 Vac (clamps 19-29)
MAX absorption 24 Vdc (clamps 30-31)
Application on sliding automation
145 x 135 x 50
500
1
750
4
40
2
300
600
100
-3-
Technical Manual
FOTO A
FOTO A2
mm
g
HP
W
A
W
A
mA
mA
mA