Using The Remote Controls - EB TECHNOLOGY START-S4XL Manual De Instrucciones

START-S4XL
7

Using the remote controls

The control board can accept diff erent type of codes, the fi rst memorized remote control defi nes the type, con-
sequently, other type of codes (diff erent from the fi rst memorized remote control) cannot be learnt. The control
board accepts standard codes from 12 to 64 bit and only the fi xed part of the code for the rolling code HCS©,
but using the DIP 3-B the rolling code counte can be monitored. This way the remote controls cannot be copied.
The memory capacity is about 200 diff erent rolling codes. The fi rst memorized remote control defi nes the type
of code that the receiver shall learn, consequently, the subsequently memorized remote controls must have the
same type of code.
7.1 FULL CANCELLATION of the memory
This operation cancels all previous memorized codes. It is not contemplated the cancellation of a single remote
control code. It is necessary to reset the memory before learning the fi rst remote control to avoid the remaining
of previously memorized codes that aren't in use in the installation.
The cancellation of the memory (all codes) is possible only when the gate is closed.
1
CODICI L1
2
CODICI L1
7.2 Learning of the remote controls
The remote controls can be learnt ONLY when the gate is CLOSED.
PERFORM THE LEARNING WITHOUT CONNECTING THE ANTENNA TO THE CLAMPS NO. 24-25
1
>
2
CODICI
3
START
>
1
CODICI
>
2
3
PEDESTRIAN
- If you need to learn a new remote control repeat the same operation.
- When you push the remote control's button and the L.E.D. codes is switched ON, it means that the remote control is not compatible.
- When you push the remote control's button and the L.E.D. codes fl ashes slowly, it means that the memory is FULL.
- In this card is not previewed the cancellation of a single remote control 's code.
Make sure that the gate is in CLOSED position.
Press and keep pressed the codes button
Wait for the LED CODES to start fl ashing, then release it.
Wait until the reset of the memory.
Make sure that the gate is in CLOSED position.
Press and release the CODICI button, the LED CODICI will stay lit.
Press the button of the remote control, ex: button no.1:
if it is memorized LED CODICI will fl ash
Press and release the CODICI button, the LED CODICI will stay lit.
Press again the CODICI button, the LED CODICI will fl ash and stay lit
Press the button of the remote control, ex:
button no.2: if it is memorized LED CODICI will fl ash
-13-
Technical Manual