Checking Connections - EB TECHNOLOGY START-S4XL Manual De Instrucciones

START-S4XL
2.12 Connection of the commands "START" and "PEDESTRIAN"
15 16 17 18 19 20 21 22 23 23 24 25
2.13

Checking connections

When the control board is powered, the "led" lights, that are placed on the inputs, are lit up when there is a closed
contact towards the common on the input.
Normally the red lights on inputs STOP - PHOTO A - PHOTO B - LSO - LSC are ON
Normally the green lights on the control inputs START - PEDESTRIAN are OFF
LSC LSO
MOT2 MOT2
3 Instruction for TEST
The TEST function is compatible with devices with slow reponse (for example TRANSCEIVER) so when those
devices are available the response time can be slower. You can test the devices in the STOP input.
Follow this procedure to know if some devices connected ot the inputs PHOTO-A, PHOTO-B and STOP are
under TEST.
ON CTS
1 2 3 4 5 6 7 8 9
LED
ON CTS
1 2 3 4 5 6 7 8 9
START
By using the clamps no. 17 and no. 24 you can connect a TIMER to program
the openings of the gate. The contact of your timer must be a type N.O. and
must stay in a close mode the whole time the gate remains opened. If there
is an opening command connection on the clamp no. 17, connect in parallel.
LSC LSO
MOT1 MOT1
1 When the control is switched OFF, put in OFF dip 8 of DIP A
10
2
Power the control unit and wait the standard fl ash of the Led
3 Put in ON DIP 8 of DIP A
10
Let the gate open with a START commande or the time learning if necessary
4 (Par. 8.1). Now the control unit check ethe devices under TEST and the
depart of the doors can be delayed.
The connection of the command for pede-
strian opening can be realized on every but-
ton or contact as soon as it is type N.O. (nor-
mally opened).
The connection of the opening command
START can be realized on every button or
contact as soon as it is type N.O. (normally
opened). If you have several devices to con-
nect you need to connect them in parallel.
START
PHOTO A
in chiusura
-9-
STOP PEDESTRIAN
Technical Manual
PHOTO B
apertura
e chiusura