Checking The Cultivator; Checking The Controls; Working With The Cultivator; Placing The Front Wheel In The Operating Position - Stihl MH 610 Manual De Instrucciones

10 Checking the Cultivator

10 Checking the Cultivator

10.1 Checking the Controls

Lock
► Stop the engine.
► Try to press the clutch lever without pressing the lock.
► If the clutch lever can be pressed: do not use the tiller and
consult a STIHL specialist dealer.
The lock is defective.
► Press the lock and hold.
► Press the clutch lever.
► Release the clutch lever and lock.
► If the clutch lever or lock is stiff or does not spring back
into the initial position: do not use the tiller and consult a
STIHL specialist dealer.
The clutch lever or lock is defective.
Clutch lever
► Start the engine.
► Set 1st, 2nd or reverse gear.
► Engage self-propulsion.
The drive is engaged and the drive shaft rotates.
► If self-propulsion does not engage:
► Do not use the tiller and consult a STIHL specialist
dealer.
The clutch lever is defective.
Main switch
► Start the engine.
► Set the main switch to the 0 position.
The engine cuts out.
► If the engine does not cut out:
► Do not use the tiller and consult a STIHL specialist
dealer.
The main switch is defective.
0478-404-9902-A
Throttle lever
► Start the engine.
► Move the throttle lever.
The engine speed changes.
► If the engine speed does not change:
► Do not use the tiller and consult a STIHL specialist
dealer.
The throttle lever is defective.
Gear lever
► Engage 0, 1st, 2nd and reverse gear.
► If one of the gears cannot be engaged:
► Do not use the tiller and consult a STIHL specialist
dealer.
The gear lever is defective.

11 Working with the Cultivator

11.1 Placing the Front Wheel in the Operating
Position
► Detach retaining pin (1) and remove pin (2).
English
21