Assembling The Cultivator; Fitting And Removing The Blades; Attaching The Hoes; Removing The Hoes - Stihl MH 610 Manual De Instrucciones

English

6 Assembling the Cultivator

6.1

Fitting and Removing the Blades

6.1.1

Attaching the Hoes

► Push hoes (1) onto drive shaft (2) so the bores align.
► Push folding retainers (3) through the bores in drive
shaft (2) and close the securing clips.
Hoes (1) are secured.
6.1.2

Removing the Hoes

► Stop the engine.
► Pull out the folding retainers.
► Remove the hoes.
► Push the folding retainers through the bores in the drive
shaft.
The folding retainers are kept in place.
6.2

Attaching and Removing the Running Wheels

6.2.1

Attaching the Running Wheels

► Stop the engine.
► Open the valve on the running wheels and allow air to
escape.
12
► Remove bolts (1) together with washers (2), spring
washers (3) and nuts (4).
► Remove rim halves (5) from rubber tyre (6).
► Place rim halves (5) and axle mount (7) on rubber tyre (6)
so the bores align.
► Insert bolts (1).
► Place washers (2) and spring washers (3) on bolts (1).
► Screw on nuts (4) and tighten.
► Push running wheels (1) onto drive shaft (2) so the bores
align.
6 Assembling the Cultivator
0478-404-9902-A