Filling Solution Tank - Nobles Speed Scrub 2701 Manual De Operación Y De Piezas

5. (For Pad Installation) Attach pads to pad drivers
before connecting drivers to motor hub. To attach
pad to driver, remove plastic centerlock ring from
pad driver. Position pad on pad driver and replace
centerlock ring (Figure 7).
6. Attach brush/pad drivers to motor hubs. Align (3)
mounting studs with slots in motor hub. Give driver
a quick turn toward spring clip located on motor
hub. Be certain pad driver is securely fastened
and spring clip locks into one of the studs before
operating machine (Figure 8).
NOTE: Always make sure pad driver and motor hub
surfaces are always clean before installing drivers.
Keeping surfaces clean will make it easier when
removing pad drivers.
7. Close skirt housing and refasten latch.

FILLING SOLUTION TANK

1. Transport machine to filling station. Raise
squeegee and brush when transporting.
2. Turn off machine.
FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.
Speed Scrubt 2701/3301 (06–01)
FIG. 7
FIG. 8
3. Shut off solution flow. Pull solution flow lever
completely back to shut off (Figure 9).
4. Open solution fill door at front of machine and fill
solution tank with clean water, 60°C (140°F)
maximum temperature. Or you can fill solution
tank using hose fill port at rear of machine. Twist
off plug and insert hose to fill. The clear tube
below the fill port has 19L (5 gallon) increment
markers to indicate amount of water in tank
(Figure 10).
FIG. 10
NOTE: If filling with a bucket be certain that bucket is
clean. This will prevent possible solution line clogs.
5. Add cleaning chemical. See proper dilution ratio
instructions on bottle.
FOR SAFETY: When using machine, follow mixing
and handling instructions on chemical containers.
ATTENTION: Use only recommended cleaning
chemicals, DO NOT use substitutes. Consult an
authorized distributor to assist you with the
recommended cleaning chemicals.
WARNING: Flammable materials can cause
an explosion or fire. Do not use flammable
materials in tanks.
OPERATION
FIG. 9
7