Draining Tanks; Draining Recovery Tank; Draining Solution Tank - Nobles Speed Scrub 2701 Manual De Operación Y De Piezas

OPERATION

DRAINING TANKS

FOR SAFETY: Before leaving or servicing
machine, stop on level surface and turn off
machine.

DRAINING RECOVERY TANK

Recovery tank must be emptied prior to refilling
solution tank. To drain recovery tank, perform the
following steps:
ATTENTION: If recovery tank is not emptied
between fill–ups, foam or water will enter vacuum
standpipe and damage vacuum motor. Float
shut–off screen will not keep foam out of
standpipe. Vacuum damage due to foam or water
is not covered by warranty.
1. Remove drain hose from holder, position hose
over floor drain and twist off drain hose plug. To
completely drain recovery tank, hinge open tank
and flip up tank support stand to rest tank on
(Figure 18).
NOTE: If using a bucket to drain machine, do not use
same bucket for filling solution tank. This will prevent
possible solution line clogs.
FIG. 18
2. Rinse out recovery tank after each use. This will
prevent foul odor buildup. Use a hose to rinse out
the recovery tank. Be careful not to spray water
into shut–off float screen.
3. Replace drain hose plug tightly when tank is
empty.
10

DRAINING SOLUTION TANK

To drain leftover cleaning solution from solution tank,
follow steps below:
1. Pull clear hose off hose barb at rear of machine
and drain solution into floor drain or bucket
(Figure 19).
FIG. 19
2. Rinse out solution tank with clean water after each
use and flush out solution flow system by pushing
solution flow lever forward. This will prevent
clogging due to chemical buildup. Use clear hose
to drain solution tank.
3. Reconnect clear hose to hose barb. Be certain
hose is completely pushed onto hose barb.
Speed Scrubt 2701/3301 (06–01)