Size And Cut Duct Piece - GE Profile PV970 Serie Manual Del Propietario E Instrucciones De Instalación

4 MOUNT THE HOOD
WARNING:
2 people are required to lift
and position the hood onto the mounting screws.
• Lift the hood onto the mounting screws.
• If using a wall fastener, make sure the washer
is in front of the flange and not behind it. Check
with a level before tightening screws.
• Install lower screws to pull the hood tight against
the wall.
Tighten
screws
Bottom
Install
screw
screws
location
Installation Instructions
INSTALLATION—RECIRCULATING
5

SIZE AND CUT DUCT PIECE

• Measure from the bottom of the air deflector
to the top of the hood as shown. Reduce that
dimension by 1" to facilitate installation.
The duct will cover and overlap the deflector
and the exhaust outlet in the hood.
• Remove the air deflector from the duct cover
bracket.
Measure
length
• Cut the duct piece to size and slip onto the bottom
of the deflector.
• Place the assembled deflector and duct over
the exhaust outlet.
• Hold the assembly against the duct bracket.
• Drive 2 screws into each side of the bottom
of the deflector and into the bracket.
• Use duct tape to seal duct to the deflector
and at the exhaust outlet.
Deflector
20
Duct
length