Interrupt Mode - Kyocera DF-650B Guía De Uso

2
3
4
DF-650(B), MT-1(B), BF-1(B), PH-4(A) AND PH-4(C) OPERATION GUIDE
Load the originals in the Document
Processor, or one at a time on the Platen.
Ensure the orientation of the originals is the
same as that selected for Hole Punch mode
on the copier.
NOTE:
Refer to the Operation Guide for your copier for Document Processor and
Platen specifications.
Select other features as required and press Start.
The copies are automatically hole punched
and ejected onto Tray B.
NOTE:
Holes are punched in each
copy individually, therefore the location
of the holes may vary on each sheet.
On completion of the job, remove all the
copies.
NOTE:
If the maximum capacity for Tray B is exceeded, all subsequent copies will
be ejected onto Tray A. If Tray A is not engaged when Tray B becomes full, an error
message displays. Remove all copies to continue.

Interrupt Mode

When using Interrupt Mode, the copies for the interrupt job are usually ejected onto
the finisher tray not currently in use. If required, a different tray can be selected on
the copier Operation Panel.
NOTE:
Refer to the Operation Guide for your copier for further details.
English
1-13