DITEC Arc B Manual Para La Instalacion Y La Manutencion página 10

- ARC BH geared motor electrical wiring and starting are
GB
shown in fig. 13, 15 (1 wing) or in fig. 14, 16 (2 wings)
and in the installation manual of Control Panel D2H and
LogicC22-C22S. To reverse the direction of rotation, ex-
change the motor phases (36 with 34 and/or 33 with 31).
5. MAINTENANCE PROGRAM (each 6 months)
Power off 230 V~ mains and batteries (if installed):
- Lubricate the levers of the geared motor.
- Lubricate the rotation pivot of the gate leaf.
- Lubricate the gate leaf hinges.
RELEASE INSTRUCTION
In case of faulty operation or power failure, remove the plug and
insert the release key supplied in the special hole on the cover.
Turn clockwise to release the right leaf; counterclockwise to
release the left leaf. Manually slide the gate open.
At end of operations, lock the geared motor again.
Attention: Lock and release operations must be performed with
motor not running.
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential part of
the product and must be supplied to the user.
Read them carefully as they contain important indications for
the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible
future user of the system.
This product must be used only for that which it has been ex-
pressely designed. Any other use is to be considered improper
and therefore dangerous.
The manufacturer cannot be held responsible for possible
damage caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving
mechanical parts.
Do not enter the field of action of the motorised door or gate
while in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger.
Do not lean against or hang on to the barrier when it is moving.
Do not allow children to play or stay within the field of action of
the motorised door or gate.
Keep remote control or any other control devices out of the
reach of children, in order to avoid possible involuntary activa-
tion of the motorised door or gate.
In case of breack down or malfunctioning of the product,
disconnect from mains, do not attempt to repair or intervene
directly and contact only qualified personnel.
Failure to comply with the above may create a situation of
danger.
All cleaning, maintenance or repair work must be carried out
by qualified personnel.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - ditec@ditecva.com
TEAR OFF AND DELIVER TO USER
OPERATING INSTRUCTION FOR ARC SWING GATES
Power on 230 V~ mains and batteries:
- Check the power adjustment.
- Check the good operation of all command and safety func-
tions (photocells).
- Check the good operation of the release system.
ATTENTION: For spare parts, see the spares price list.
ON
OFF
In order to guarantee that the system works efficiently and
correctly it is indispensable to comply with the manufacturer's
indications thus having the periodic maintenance of the moto-
rised door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly.
All installation, maintenance and repair work must be docu-
mented and made available to the user.
Installer: