Firmware Update - DJI 2600W Guia Del Usuario

Blinks red once
continuously
Blinks red twice
continuously
Solid red
Note: The quick charge or slow charge indicator will remain solid during charging.
If the status LEDs do not light after the batteries and the power outlet are correctly connected,
there may be a problem with the battery charger. In this situation, the warning indicator will
light to indicate the following abnormalities:
Warning Indicator
Solid red
Solid yellow
Blinks yellow twice continuously
Blinks yellow three times continuously
Blinks red once continuously
Solid red
If there are any abnormalities, please connect the battery charger to a remote controller and run
the DJI MG app or DJI Agras app to see more information. If the app indicates that a module is
abnormal or broken, please contact DJI or a DJI authorized dealer.

Firmware Update

Follow the instructions below to update the firmware using the DJI MG app or DJI Agras app. Users
will be notified through the app when firmware updates are available.
1. Connect the battery charger to a remote controller using a USB Type-C cable and connect the
battery charger to a power outlet.
2. Power on the remote controller, and press the Power button on the operational panel to power
on the battery charger.
3. Run the app, and follow the prompts to update the firmware. Make sure your remote controller
remains connected to the internet while updating.
Before using the battery, make sure there are no obvious defects on the ports or cables
of the battery charger (e.g., jams, breakages, or short circuits).
DO NOT connect the batteries while updating the battery charger's firmware.
DO NOT disconnect the battery charger while updating the battery charger's firmware.
Retry update if update fails.
The battery in the corresponding position is not
correctly connected or an unauthorized battery is
D.D.D...
connected (this warning will only appear 10 seconds
The connector short-circuited. Please check the
DD.DD.DD...
DDD.DDD...
Warning Sound
/
/
/
/
D.D.D......
DD.DD.DD......
after the battery is connected).
battery or the battery charger.
Critical error detected.
Description
Self-diagnosis abnormal
The input voltage is too low
The fan of the 4850 module is abnormal
The battery charger fan is abnormal
The 4850 module is abnormal
Main board is abnormal
©
2019 DJI All Rights Reserved. 9