Using The Battery Charger - DJI 2600W Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 52
Activation
The battery charger requires activation before using for the first time. If the warning indicator is
solid green, it means the battery charger has not been activated. Please follow the steps below to
activate your battery charger:
Method 1: Using DJI MG App or DJI Agras App
1. Connect the battery charger to a power outlet.
2. Connect the battery charger to your remote controller using a USB-C cable (not provided).
3. Run the app.
4. Press the Power button to power on the battery charger.
5. Follow the prompts to finish activation.
Method 2: Using DJI ASSISTANT™ 2
1. Connect the battery charger to a power outlet.
2. Connect the battery charger to your PC using a USB-C cable (not provided).
3. Visit www.dji.com to download DJI Assistant 2. Install and run the software.
4. Use your DJI account to log in.
5. Press the Power button to power on the battery charger.
6. Click "2600W 4-Channel Intelligent Battery Charger" and follow the prompts to finish activation.
Make sure your PC or smart device can connect to the internet during activation.
Internet

Using the Battery Charger

Make sure that the GND cable is connected to the GND Port with the other end on the ground and
follow the instructions below to use the battery charger. Up to 4 batteries can be connected to the
2600W 4-Channel Intelligent Battery Charger.
1. Connect the battery charger to a power outlet.
Insert the GND cable here
with the other end grounded
©
2019  DJI All Rights Reserved.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido