Storage And Maintenance - DJI 2600W Guia Del Usuario

Storage and Maintenance

Battery Charger Storage
When the battery charger is not in use, disconnect the batteries from the battery charger and the
battery charger from the power outlet. Follow the steps below to safely secure the charging cables.
1. After disconnecting a battery, wrap the charging cable over the battery charger.
2. Make sure the end of the charging cable is securely attached to the corresponding clamp on the
side of the battery charger.
For the battery charger compatible with MG-12000P batteries, it is only necessary to secure the
charging cable end to the clamp on the side of the battery charger.
Replacing the Charging Cables
Follow these steps to replace the charging cables:
1. Loosen the screws and remove the panel.
2. Loosen the A and B screws, and press the C cable to disconnect the charging cable. Make sure
the charging cable is pointed vertically and slide the charging cable to the right to disconnect
from the battery charger completely.
©
10 2019 DJI All Rights Reserved.