Stihl FS Manual De Instrucciones página 49

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FCS
FH/HL
HT
SP
FS
SP 10
Loosen the clamp screws (arrows)
N
on the gearbox housing – do not
remove them.
Pull the gearbox off the drive tube.
N
If the drive shaft slips out of the tube
when you pull off the gearbox:
Push the drive shaft into the tube.
N
L
The drive shaft must not project from the
tube more than L = 22 mm (7/8 in).
If dimension (L) is not correct:
Apply slight pressure to the drive
N
shaft and rotate it slowly at the same
time until it can be pushed in to the
specified length.
Mounting the Gearbox
A
Apply a mark (with pencil or felt-tip
N
pen) at distance A (40 mm/1.6 in)
from the end of the drive tube.
Place the power tool on the ground
N
so that it rests on the machine
support.
1
Loosen the clamp screws (1) on the
N
gearbox – do not remove them.
English
47

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido