Safety Instructions For Abrasive Cutting Appliances - Parkside PTS 710 A2 Traducción Del Manual De Instrucciones Original

Supplementary notes:
■ Do not use any grinding discs.
■ Use only saw blades with diameters corre-
sponding to the label on the saw.
■ When working with wood or materials that
produce dust hazardous to health, the appli-
ance must be connected to a suitable, tested
extraction appliance.
■ Wear a dust mask when sawing wood.
■ Only use recommended saw blades.
■ Always wear ear muffs.
■ Avoid overheating the sawtooth tips.
■ When sawing plastic, avoid melting the plastic.
■ Use the correct saw blade according to the
material to be sawn.
■ Use only saw blades specified by the manu-
facturer which, if intended for cutting wood or
similar materials, comply with EN 847-1.
■ Tools may only be used by trained and expe-
rienced persons who are familiar with the use
of tools.
■ Circular saw blades with torn bodies must be
taken out of service (repair is not permitted).
■ The maximum speed indicated on the tool must
not be exceeded. If specified, the speed range
must be observed.
Circular saw blades (symbols)
Wear protective gloves!
Wear a dust mask!
Wear safety goggles!
Wear ear muffs!
PTS 710 A2
Safety instructions for abrasive
cutting appliances
a) The blade guard, which is a part of the pow-
er tool, must be attached securely and set in
a way that ensures maximum safety, i.e. the
smallest possible amount of the grinding tool
is exposed to the operator. Ensure that you
and anyone else in the vicinity remain outside
of the range of the rotating grinding disc. The
blade guard is designed to protect the operator
from fragments and accidental contact with the
grinding tool.
b) Use only diamond-coated cutting discs for
your power tool. Just because you can attach
the accessories to your power tool, does not
ensure they are safe to use.
c) The permissible speed of the accessory tool
used must be at least as high as the maximum
speed specified for the power tool. Accessories
which rotate faster than the maximum permissi-
ble rate can break and throw pieces into the air.
d) Grinding tools should only be used for the
recommended applications.
For example: Never grind with the side sur-
face of a cutting disc. Cutting discs are de-
signed to remove material with the edge of the
disc. Any lateral application of force on these
grinding tools can lead to a breakage.
e) Always use an undamaged clamping flange
of the correct size and shape for the selected
grinding disc. Suitable flanges support the
grinding disc and reduce the risk of a disc
breakage.
f) Do not use worn grinding discs from larger
power tools. Grinding discs for larger power
tools are not designed for the higher rotational
speeds of smaller power tools and can break.
g) The external diameter and thickness of the
accessory tool used must comply with the
dimensions of your power tool. Incorrectly
dimensioned accessory tools cannot be suffi-
ciently shielded or controlled.
h) Grinding discs and flanges must fit precisely
onto the grinding spindle of your power tool.
Accessory tools which do not fit precisely on
the grinding spindle of the power tool will rotate
unevenly, vibrate severely and can lead to a
loss of control.
GB │ MT │
61 ■