Technical Data; General Warnings; Correct Usage - Rupes RA75 Instrucciones De Uso Y Manutención

TECHNICAL DATA

TYPE
WORKING PRESSURE bar/PSIG
AIR CONSUMPTION l/min
SPEED CONTROL
RPM
ORBITAL DIAMETER mm
DISC PAD DIAMETER mm
EXTRACTION SYSTEM
WEIGHT Kg

GENERAL WARNINGS

The tool must be connected to a suitable dust extraction system RA75A - RA90A (not supplied).
The safety and accident prevention instructions are reported in
the "SAFETY INSTRUCTION" booklet which forms an integral part
of these documents. This OPERATING INSTRUCTION MANUAL
indicates the additional information required specifically for use
of the tool.

CORRECT USAGE

This tool is designed to be used as a sander. Read all the war-
nings, instructions, indications provided on drawings and specifi-
cations supplied with this tool.Failure to comply with all the instruc-
tions provided below may cause serious injuries.
This tool is not intended to be used for metal brushing,polishing
and cutting operations. The use of this tool for unintended applica-
tions may cause hazards and injuries to people.
Do not use accessories that are not specifically designed for the
intended use of the tool or that have not been recommended by
the manufacturer. The fact that an accessory can be fixed to the tool
does not imply that it can be used safely.
The rated speed of the accessory must be at least equivalent to
8
RA75 - RA75A
6,2/90
380
YES
OFF÷11.000
3
75
RA75A
0,680
the maximum speed specified on the tool. Using the accessories at
speeds above the rated one, may cause them to break or be projec-
ted into the air.
The external diameter and thickness of the accessory must match
the specifications of the electrical tool. Accessories with incorrect
dimensions cannot be adequately protected or controlled.
The configuration of accessories must match the tool. The use of
accessories that cannot be perfectly fitted on the tool may result in im-
balance, excessive vibrations and in the impossibility of controlling the
tool.
Do not use damaged accessories. Before use, inspect all the ac-
cessories. Inspect the supporting pads and verify there are no
cracks, tears or excessive wear. If the tool or accessory has fallen,
verify that it is not damaged or install a new accessory. After in-
specting or installing an accessory, move to a safe distance with
any other person present and operate the tool at maximum speed
without load for one minute. Damaged accessories generally break
during this test period
ENGLISH 8
RA90 - RA90A
6,2/90
320
YES
OFF÷8.500
3
90
RA90A
0,70