Preselecting The Speed; Maintenance And Care - Flex PE 8-4 80 Instrucciones De Funcionamiento

PE 8-4 80

Preselecting the speed

 To set the operating speed, move the
dial to the required value.
CAUTION!
Risk of injury due to destruction of the tool.
Use the appropriate tool for the job.
NOTE
If an overload or overheating occurs during
continues operation, the power tool auto-
matically reduces the speed until the power
tool has cooled down adequately.
Attaching or changing the tool
holder
 Pull out the mains plug.
 Press and hold down the spindle lock.
 Screw chuck clockwise onto the spindle
and tighten hand-tight.
To loosen, turn chuck anti-clockwise.
Attach or change tools
 Pull out the mains plug.
 Press polishing agent firmly in the centre
of the Velcro pad. Use undamaged
polishing tools only.
 Carry out a test run to check that the tool
is clamped in the centre.
Operating instructions
NOTE
When the power tool is switched off, the tool
continues running briefly.
If using a polishing paste, use the
–
respective tool for each paste.
In the case of sensitive surfaces
–
(e. g. car paint) do not work
aggressively, but at low speeds and with
low contact pressure.
Sponges can be washed in the washing
–
machine.

Maintenance and care

WARNING!
Before carrying out any work on the
polisher, always pull out the mains plug.
Cleaning
WARNING!
If metals are work over a prolonged period,
conductive dust may become deposited
inside the housing. Impairment of the
protective insulation! Operate the power tool
via a residual-current-operated circuit-
breaker (tripping current 30 mA).
Regularly clean the power tool and
ventilation slots. Frequency of cleaning is
9