Selecting Scenes; Temporarily Adjusting Light Levels And Shade Positions - Lutron GRAFIK Eye 4000 Serie Manual De Instalación

Section 5:
Using the GRAFIK Eye
NOTE: For slider units, this section is covered in the Addendum included with those units.
This section describes how to use your GRAFIK Eye control unit, including selecting scenes, making temporary
changes, and setting up system communications.

Selecting Scenes

ZONE 5 ZONE 6

Temporarily Adjusting Light Levels and Shade Positions

You can temporarily adjust the light level or shade position of a zone. Temporary adjustments remain in effect only
until a new scene selection occurs.
NOTE: For control units set to bd save mode (refer to page 21), temporary adjustments can be made only using a
wallstation, shade controller, or IR control.
ZONE 5 ZONE 6
ZONE
raise/lower
buttons
LED Displays for Temporarily Changing Lighting Settings
Lighting
Level (%) LED DIsplay
0
1-13
14-28
29-42
Legend:
LED lit
LED off
22 GRAFIK Eye 4000 Series Control Unit Installer's Guide
®
FADE TEMPORARY
ZONES
M S
MASTER
Scene 1
Scene 2
Scene 3
Scene 4
OFF
TEMPORARY
LED
FADE TEMPORARY
TEMPORARY
ZONES
ZONES
M S
MASTER
MASTER
raise/lower
SCENE
buttons
Lighting
Level (%)
43-56
57-70
71-85
86-100
Control Unit
®
To select a scene, press the corresponding SCENE
button on the control unit. The first button calls up scene
1; the second button, scene 2; and so on. The last button
is the OFF scene.
Scenes 1 through 4 (and OFF) can be selected on the
control unit.
Scenes 5 through 16 are selected only by using
wallstations and other optional control interfaces. (For
installation and setup procedures, refer to the separate
instructions provided with the wallstation or interface.)
To temporarily adjust all lighting zones:
1. Press the appropriate scene button.
2. To raise or lower the intensity of all lighting zones
in the scene, press the MASTER 5 or 6 button.
(This will not affect shade zones or unaffected
lighting zones.)
To temporarily adjust a lighting zone:
1. Press the TEMPORARY ZONES button so the
TEMPORARY LED above the TEMPORARY ZONES
button lights.
2. Press the ZONE 5 or 6 button to adjust any
zone's light level.
LED DIsplay
R