Cleaning The Filters - Vortice HRI MINI Manual De Instrucciones

ENGLISH
NOTE: Do not break open the fan case assembly as this will void the warranty.
Replace fan assembly and refit in reverse order.
SYSTEM MAINTENANCE: CHECK OWNER REGIME FOR FREQUENCY
Clean unit filters and any inline filters that may be fitted in accordance with the filter's manufacturers instructions.
Clean the filter grille mesh in the extract grille if fitted.

CLEANING THE FILTERS

The machine is equipped with a "Filter cleaning indicator" indicated by a LED positioned on the potentiometer supplied with
the machine. In the presence of the flashing LED the machine signals that the filters are dirty or to be replaced.
Remove the filters by first removing the magnetic strips, clean them or replace them and storing them back in the machine,
then reset the filter cleaning alarm by pressing for 2 seconds the red button on the machine as shown in Fig. A
Remove all debris with a soft brush or vacuum cleaner.
NOTE: DO NOT USE WATER OR ANY OTHER FLUIDS.
40
A
Filter
button
alarm
reset