Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English / USA
3
4
R
3
R
:
Use green-coded nylon line with a
diameter of 2 mm (0.08 in).
:
Cut two 3 m (10 ft) lengths of nylon
line from the replacement reel – see
'Special Accessories'.
Insert the end of each line (3) in the
holes (4) in the spool.
:
Bend the ends of the lines over the
edge of the holes to form a hook.
22
5
:
Straighten out the nylon lines and
wind them tightly onto the spool –
one nylon line in each chamber.
:
Engage the ends of the nylon lines
in the notches (5).
Assembling the Mowing Head
Before assembling, check that the
compression spring is installed (see
"Mounting the Mowing Head").
5
6
:
Thread the ends of the lines (6)
through the sleeves (7) and push
the spool (2) into the head so that
snaps into position.
Nylon lines must disengage from
the notches (5) as the spool is
pushed into position.
:
Pull out the ends of the lines as far
as stop.
:
Mount the mowing head on the
machine.
2
6
7
FSB-KM
Publicidad
Capítulos
Tabla de contenido
