Environment Protection - Worx WG500E Manual Del Usuario

altered by turning the variable speed selector.
Turn upward to decrease and downward to
increase speed.
EMPTYING THE BAG
Turn off and unplug the vacuum from the
power source. Empty the Bag as in FigI-J.
Do not store debris in the bag.To clean the
bag, turn it inside out and shake out any
excess debris. Once a year, hand wash the bag
in soapy water and allow it to air dry.
WARNING: Normal usage of the bag
causes it to wear and deteriorate over
time. A worn or deteriorated bag allows small
objects to be thrown through the bag, possibly
injuring the operator or bystanders. Check the
bag frequently. If it is worn or deteriorated,
replace it with a vacuum bag.
REMOVING CLOGGED DEBRIS FROM THE
IMPELLER
1. Turn off and unplug the vacuum from the
power source and wait for all moving parts
to stop.
2. Move the on/off switch (2) to ''0''position
firstly, and then press the release button (3),
so that you can separate the tube.(Fig K)
3. Then you can remove the debris as shown
10 10
in Fig L.
4. Check the impeller for any signs of damage.
If it is damaged, contact your Authorized
Dealer.
5. Install the Blower/VacuumTube.
STORAGE
Store the blower/vacuum and extension cord
indoors, in a cool dry location, out of reach of
children and animals.

ENVIRONMENT PROTECTION

Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
All-in-one blower/vac/mulcher
PLUG REPLACEMENT (UK &
IRELAND ONLY)
If you need to replace the fitted plug then
follow the instructions below.
IMPORTANT
The wires in the mains lead are colored in
accordance with the following code:
Blue – Neutral
Brown – Live
As the colors of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals
in your plug, proceed as follows.The wire
which is coloured blue must be connected to
the terminal which is marked with N.The wire
which is coloured brown must be connected to
the terminal which is marked with L.
WARNING: Never connect live or neutral
wires to the earth terminal of the plug. Only
fit an approved BS1363/A plug and the correct
rated fuse.
NOTE: If a moulded plug is fitted and has to
be removed take great care in disposing of the
plug and severed cable, it must be destroyed
to prevent engaging into a socket.
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip
EN