Environmental Protection - Worx WG518E Manual De Instrucciones

OPERATION
INTENDED USE:
The blower is intended for residential use only. Use
the blower outdoors to move yard debris as needed.
ASSEMBLY AND OPERATION
ACTION
Assembling & disassembling the
Blower Tube
Starting & Stopping
WARNING: The tool runs for
a few seconds after it has been
switched off. Let the motor come to
a complete standstill before setting
the tool down.
Using the Blower
Hold the blow tube approximately
8—20cm above the ground when
operating the tool.
Use a sweeping motion from side
to side. Advance slowly keeping the
accumulated debris/leaves in front
of you.
After blowing the debris/leaves into a
pile, it is easy to dispose of the pile.
CAUTION!
- Do not blow hard objects such as
nails, bolts, or rocks.
- Do not operate the blower near
bystanders or pets.
- Use extra care when cleaning debris
from stairs or other tight areas.
- Wear safety goggles or other suitable
eye protection, long pants and shoes.
Adjusting the Blowing Speed
Variable Speed Switch
STORAGE
Store the blower and extension cord indoors, in a cool
dry location, out of reach of children and animals.
CLEANING THE TOOL
Clean the tool regularly.
WARNING! Keep your product dry.
Under no circumstances spray with water.
—To clean the tool, use only mild soap and a damp
cloth.
—Do not use any type of detergent, cleaner or
solvent which may contain chemicals that could
seriously damage the plastic.
—Self lubricating bearings are used in your product,
therefore lubrication is not required.
Electric Blower
ENVIRONMENTAL
PROTECTION
local authorities or retailer for recycling advice.
PLUG REPLACEMENT
FIGURE
(UK & IRELAND ONLY)
See Fig. A&B
If you need to replace the fitted plug then follow the
instructions below.
IMPORTANT
See Fig. C
The wires in the mains lead are colored in
accordance with the following code:
Blue = Neutral
Brown = Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug,
proceed as follows. The wire which is coloured blue
must be connected to the terminal which is marked
with N. The wire which is coloured brown must be
connected to the terminal which is marked with L.
See Fig. D
approved BS1363/A plug and the correct rated fuse.
NOTE: If a moulded plug is fitted and has to be
removed take great care in disposing of the plug
and severed cable, it must be destroyed to prevent
engaging into a socket.
See Fig. E
Waste electrical products must not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
WARNING! Never connect live or neutral wires
to the earth terminal of the plug. Only fit an
9
EN