Environment Protection; Emptying The Bag; Removing Clogged Debris From The Impeller - Worx WG500E Traducción De Las Instrucciones Originales

IMPORTANT: Do not force the vacuum tube
into a pile of debris or hold the tube upright
while force feeding debris into the tube. Either
action may clog and damage the impeller.
If the vacuum starts to vibrate or make
abnormal noise, stop it, unplug the cord, and
check for the cause.
VARIABLE SPEED CONTROL
The maximum speed of the blower can be
altered by turning the variable speed selector.
Turn upward to decrease and downward to
increase speed.

EMPTyING THE BAG

Turn off and unplug the vacuum from the
power source. Empty the Bag as in FigI-J.
Do not store debris in the bag. To clean the
bag, turn it inside out and shake out any
excess debris. Once a year, hand wash the bag
in soapy water and allow it to air dry.
wARNING: Normal usage of the bag
causes it to wear and deteriorate over
time. A worn or deteriorated bag allows small
objects to be thrown through the bag,
possibly injuring the operator or bystanders.
Check the bag frequently. If it is worn or
deteriorated, replace it with a vacuum bag.
REMOVING CLOGGED DEBRIS FROM
THE IMPELLER
1. Turn off and unplug the vacuum from the
power source and wait for all moving parts
to stop.
2. Move the on/off switch (2) to ''0''position
firstly, and then press the release button
(3), so that you can separate the tube.(Fig
K)
3. Then you can remove the debris as shown
in Fig L.
4. Check the impeller for any signs of
damage. If it is damaged, contact your
Authorized Dealer.
5. Install the Blower/Vacuum Tube.
STORAGE
Store the blower/vacuum and extension cord
indoors, in a cool dry location, out of reach of
children and animals.
All-in-one blower/vac/mulcher
EnViROnMEnT
pROTEcTiOn
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
11 11
En