Franklin Electric SubDrive 50 Manual Del Usaurio página 41

Code Fault
F19 Communication Fault • Cable connection between
F22 Display/Wi-Fi Board
Expected Fault
F23 Main Board Startup
Fault
F24
Invalid DIP Switch
Setting
F25 Moisture Sensor Fault • Moisture Sensor has detected
F26 Aux Input Fault
F27 Pressure Transducer
Error
Possible Cause
Display/Wi-Fi Board and Main
Control Board is loose or
disconnected
• Internal circuit failure
• Connection between Display/
Wi-Fi Board and Main Control
Board was not detected at drive
start-up
• A fault was found internal to
drive
• No DIP Switch set or more than
one (1) DIP Switch set for Motor
size
• No DIP Switch set or more than
one (1) DIP Switch set for Pump
size
• Invalid combination of DIP
switches for drive type (SD or
MD mode), Motor hp, and Pump
hp.
moisture or water
• External device wired to the WET
SENSOR terminal has satisfied
the configured fault condition
• Input is incorrectly configured
• External device wired to the AUX
IN terminal has satisfied the
configured fault condition
• Input is incorrectly configured
• Pressure transducer has failed
• Pressure transducer is incorrectly
wired
• Pressure transducer signal is
outside of the expected range
• Pressure transducer is
disconnected
• Pressure transducer is being
used but DIP SW1 Position 5 is in
the UP position
• Pressure Sensor is being used
but SW1 Position 5 is in the
DOWN position
Corrective Action
• Check cable connection between Display/Wi-Fi Board and Main
Control Board.
• If problem persists, unit may require replacement. Contact your
supplier.
• Check cable connection between Display/Wi-Fi Board and Main
Control Board.
• If problem persists, unit may require replacement. Contact your
supplier.
• Contact your Franklin Electric Service Personnel
• Unit may require replacement. Contact your supplier.
• Check DIP switch settings
• Check Moisture Sensor location for moisture or presence of
water. Clean and dry area. Drive will restart when moisture or
water is no longer detected.
• Ensure Moisture Sensor input is configured correctly
• Ensure the Auxiliary Input is configured correctly
• Check pressure transducer wiring connections
• Ensure DIP SW1 Position 5 is in the correct position for the
sensor type being used (DOWN for pressure transducer, UP for
pressure switch)
• Replace pressure transducer
MAINTENANCE
Troubleshooting
41