Generator Sizing; Unpacking And Inspection; Transportation And Storage; Unpacking - Franklin Electric SubDrive 50 Manual Del Usaurio

UNPACKING AND INSPECTION

Generator Sizing

Generator Sizing
Basic generator sizing for the SubDrive Connect system is 1.5 times the maximum input watts consumed by
the drive, rounded up to the next normal-sized generator.
Recommended minimum generator sizes:
Model Generator
SubDrive 15 3500 Watts
SubDrive 20 5700 Watts
IMPORTANT: Do not use with a Ground Fault Circuit Interrupter (GFCI). If using an externally regulated gen-
erator, verify that the voltage, hertz, and idle speed are appropriate to supply the drive.
UNPACKING AND INSPECTION

Transportation and Storage

Risk of damage to drive or other equipment.
• Do not stack drive boxes higher than standard 48" cube height when palleting for storage.
• Do not place heavy items on drive.
• Do not drop drive or subject it to hard impact.
• Dispose of drive properly as industrial equipment waste.
The drive should be stored in the shipping carton or crate before installation.

Unpacking

Risk of personal injury or damage to drive or other equipment.
• Use suitable lifting equipment, in good condition, rated for at least 5 times the weight of the drive.
1. Inspect exterior of package for shipping damage. If there is damage, notify the shipping agent and your
sales representative.
2. Make sure the part number and product ratings on the identification label are correct for the applica-
tion.
3. Remove drive from the box and check for damage.
4. Remove the drive cover and make sure the product ratings on the nameplate match the package label.

What's in the Box

1. Variable Frequency Drive (VFD)
2. Pressure Transducer
3. Transducer Cable
4. Screwdriver/Adjustment Tool
5. Strain Relief Fitting
6. Owner's Manual
10
Model Generator
SubDrive 30 7000 Watts
SubDrive 50 11000 Watts