Kit Assembly; Iso Din Radio Provision With Pocket - Metra 99-5827B Instrucciones De Instalación

ISO DIN radio provision with pocket

1. Mount the factory display to the radio
housing brackets with the supplied
carriage bolts and Keps nuts. (Figure A)
2. Mount the pocket to the radio housing
bracket/display assembly with the
(4) #8 x 3/8" Phillips screws supplied.
(Figure B)
3. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
4. Slide the radio into the radio bracket
assembly and secure with screws
supplied with the radio. (Figure B)
5. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
4

KIT ASSEMBLY

(Figure A)
Detail
6. Mount the assembly into the sub dash.
7. Reassemble the dash in the reverse
order of disassembly using the
99-5827B trim panel instead of the
factory panel.
Note: The integrated buttons on this kit
are used to navigate the factory display
above the radio. The button below the
info button can be used to turn the
factory screen on and off if desired.
The remainder of the control functions
are the same as factory was prior to
aftermarket installation.
Continue to ASWC-1 programming
(Figure B)
|
1.800.221.0932 MetraOnline.com