Preparation before operation
How to Insert the Batteries
Remove the battery cover by pulling it according to the
arrow direction.
Insert new batteries making sure that the (+) and (-) of
battery are installed correctly.
Reattach the cover by sliding it back into position.
NOTES:
• Use 2 AAA(1.5volt) batteries. Do not use rechargeable
batteries.
Storage and Tips For Using the Remote Control
• The remote control may be stored mounted on a
wall.
Signal Receptor
Receives the signals from the remote control.(Signal receiving sound: two short beeps or one long beep.)
Operation Indication Lamps
On/Off
Sleep Mode
Timer
Defrost Mode
OUT
OUTDOOR UNIT
OPERATION
DOOR
: Lights up during the system operation.
: Lights up during Sleep Mode Auto operation.
: Lights up during Timer operation.
: Lights up during Defrost Mode or Hot Start operation (Heat pump model only)
: Lights up during outdoor unit operation. (Cooling model only)
4
• To operate the room air conditioner, aim the
remote control at the signal receptor which is
located on the center or the right side of the indoor
unit.