With Windows® 2000 - Brother P-Touch 9200DX Guía De Referencia Rápida

G In the Add New Hardware Wizard dialog box that
confirms that installation is complete, click the Finish
button.
H In the USB Connection dialog box that confirms that
installation is complete, click the Finish button.
I Remove the CD-ROM from the computer, select "Yes,
I want to restart my computer now.", and then click
the Finish button to restart the computer.
With Windows® 2000:
Installation should be performed in the following order:
(1) P-touch Editor Version 3.1
(2) Printer driver
(3) USB class driver
(4) Port monitor
1 With a USB installation, the P-touch should not be
connected to the computer before installing P-touch
Editor Version 3.1.
. Make sure that the P-touch is not connected to the
computer, otherwise P-touch Editor Version 3.1 may
not be installed correctly.
2 Insert the P-touch Editor CD-ROM into the computer's
CD-ROM drive. A dialog box that allows you to select
what to install automatically appears.
14
If the dialog box does not automatically appear,
double-click "My Computer" on the desktop, double-
click the icon for the CD-ROM drive containing the
CD-ROM, and then double-click "Ptsetup.exe" to
display the dialog box.
3 Click the top button (P-touch Editor).
(1) P-touch Editor Version 3.1 installation
4 Install P-touch Editor Version 3.1 according to the
procedure described in P-touch Editor Version 3.1
Installation on pages 20 through 21.
5 After installation of P-touch Editor Version 3.1 is
finished, install the USB printer driver as described
below.
(2) USB printer driver installation
6 In the Port Selection dialog box that appears, select
"USB", and then click the Next button.
7 The USB message dialog box appears. (Do not click
the Finish button.)
8 Connect the P-touch to the computer using the
enclosed USB interface cable, and then turn on the P-
touch.
9 After the Found New Hardware dialog appear, click
the Next button in the first Add New Hardware
Wizard dialog box that appears.