Machine Dimensions; Dimensional Clearances - Alliance Laundry Systems SF135PV Operación Y Mantenimiento

Machine Dimensions

Refer to Figure 3 for dimensions of the 135 pound
capacity model. Refer to Figure 4, Figure 5, and
Figure 6 for dimensions of the 250 pound capacity
models.

Dimensional Clearances

Table 1 below shows recommended minimum
clearances on all sides of the washer-extractor.
Washer-extractors equipped with the tilt option require
a minimum overhead clearance, as well. Refer to
Figure 7 for the minimum overhead clearance for the
250 pound capacity model with tilt option.
Minimum rear clearance
Minimum clearance between washer-extractor
and wall
Minimum clearance between washer-extractors
(side)
Minimum front clearance
Minimum overhead clearance
F232102
Cabinet Freestanding
Recommended Minimum Clearances
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NOTE: The dimensions shown here are for
planning purposes only. They are approximate and
subject to normal manufacturing tolerances. If
exact dimensions are required for construction
purposes, contact the distributor or manufacturer.
We reserve the right to make changes at any time
without notice.
135
Standard Standard
24 in. 24 in.
(610 mm) (610 mm)
18 in. 18 in.
(457 mm) (457 mm)
18 in. 18 in.
(457 mm) (457 mm)
23 in. 36 in.
(584 mm) (914 mm)
60.5 in. 88 in.
(1537 mm) (2235 mm)
Table 1
Installation
250
Forward Tilt Two-Way
Option Tilt Option
36 in. 36 in.
(914 mm) (914 mm)
18 in. 18 in.
(457 mm) (457 mm)
18 in. 18 in.
(457 mm) (457 mm)
36 in. 36 in.
(914 mm) (914 mm)
108 in. 108 in.
(2743 mm) (2743 mm)
15