2.
Installation and any transformation for using other types of gas, must be performed by qualified technicians according
to the law in force.
See technical data tables II.
WARNINGS:
Should the unit be installed against a wall, the latter must be heat resistant to temperatures of 80°C and must be fireproof.
Before proceeding with the installation, remove the protective plastic film from the relevant parts, eliminating any adhesive
residues with an appropriate cleaning product suitable for stainless steel.
Install the unit in a horizontal position; its correct levelling will be achieved by rotating the adjustable feet.
If the unit is installed by itself, it is advisable to fasten it to make its stability safer.
2.1
INFORMATION ON THE GAS OVEN G77/FB8
This handbook applies to all G77/FB8 ovens of the OPTIMA series, type A1, category II (natural gas and LPG).
See charts tables II.
The label is in compliance with the regulations EN437 and EN203-1-2, and are situated:
Example for Italian labels: Cat. II 2H3+
Pe = Initial pressure
Pi = Pressure at the nozzle
2.2
LAWS, REGULATIONS AND TECHNICAL DIRECTIVES
When installing the oven the following rules are to be observed:
- Regulations on accident and fire prevention
- Rules of the local gas management body; an authorisation of this body is necessary before installing the oven
- Rules on the 'installation of gas equipment'
- Hygienic regulations
2.3
INSTALLATION PLACE
- The unit should be installed in adequately ventilated places. (This unit requires a draft of at least 2cu.m/hr l kW T.C.
(Thermal Capacity).
- Install the equipment in compliance with the safety rules applicable in the country where the equipment is installed.
2.4
POSITIONING
- The various units may be installed individually or together with other units of our range.
- The distance between side walls must be a minimum of 10cm; should the distance be less or the wall or floor material be
flammable, it is essential to use a thermal insulator.
GB
INSTALLATION INSTRUCTIONS
20,37,50
- 14 -
MK