Operation; Switching The Pump On And Off; Configuration Of The Pump - Ecolab EcoAdd Serie Instrucciones De Servicio

9

Operation

Personnel:
9.1

Switching the pump on and off

Fig. 85: EcoAdd
1 Touchscreen
2 On/off button
Input and settings are solely carried out via the touchscreen (Fig. 85, Pos. 1).
1. The pump is switched on via the 'ON / OFF button'
2. After activation, the pump is ready for operation.
ð When starting, the pump shows the information screen displaying the retrieved
technical data and the connected components.
3. Pressing the 'start button'
4.
Pressing the 'pause button'
ð The 'operating screen' pauses and the pump goes into "standby" mode.
5. By pressing the 'ON / OFF button'
again.
ð The 'operation screen' goes blank and the pump is switched off.
9.2

Configuration of the pump

The pump must be configured before operation and this process is described
Ä Chapter 7.10 'Overview - Configuration' on page 87.
in:
n Production supervisor
n Operator
n Specialist
initiates the pump operation.
stops the pump operation.
131
3 USB connection for data transfer
(Fig. 85, Pos. 2).
(Fig. 85, Pos. 2) the pump can be switched off
Operation
417102276 Rev. 3-01.2019