Setting Or Changing The Pump Capacity In L - Ecolab EcoAdd Serie Instrucciones De Servicio

Operation
9.3

Setting or changing the pump capacity in L

The following screens show example displays for a pump with capacity of
11 l/h. Specifications and information shown will differ for other pump sizes.
Fig. 86: Changing the pump capacity in L during ongoing operation
Set or change the pump capacity in L:
1. On the operation screen, press the displayed 'capacity in L' :
2. If a password prompt is not displayed, you can skip this step.
ð The screen switches to the screen for setting the 'capacity in L' .
3. Use the scrollbar to set the 'capacity in L' before the decimal point.
4. Select the field for entering the value after the decimal point.
ð The colour changes to dark blue, which indicates that the field is ready for input.
5. Use the scrollbar to set the 'capacity in L' after the decimal point.
6.
Press the
ð The pump saves the settings and switches back to the operation screen.
The operation screen shows the new 'capacity in L' .
417102276 Rev. 3-01.2019
To access the settings, press and hold the displayed 'capacity in L' for
around 3 seconds.
If the [access code] is enabled
Ä Chapter 7.7 'Main menu' on page 67.
NOTICE!
We strongly advise that you enable the security settings.
Ä Chapter 7.10.4 'Access code' on page 92
button.
, please note the following:
132