Beta REV-3 Manual Del Usuario página 53

3
GB
Bleeding of front brake Bleeding of front brake Bleeding of front brake
Bleeding of front brake Bleeding of front brake
To bleed air from the front brake circuit,
proceed as follows:
•Remove the rubber cap A A A A A from valve B B B B B
•Open the oiI sump cap
•Insert one end of a tube into valve B B B B B
and the other end into a container
•Unscrew the valve and pump with the
brake lever until obtaining a continuous
outflow of oil with no air bubbles. During
this procedure, you must continuously top
up the brake pump tank to replace the
oil that is removed
•Tighten the valve and replace the rubber
cap
•Remove the tube.
Bleeding of rear brake Bleeding of rear brake Bleeding of rear brake Bleeding of rear brake Bleeding of rear brake
To bleed air from the rear brake circuit,
proceed as follows:
•Remove rubber cap C C C C C
•Open the oil sump cap
•Insert one end of a tube into valve D D D D D
and the other end into a container
•Unscrew the valve and pump with the
brake lever until obtaining a continuous
outflow of oil with no air bubbles. During
this procedure, you must continuously top
up the brake pump tank to replace the
oil that is removed
•Tighten the valve and replace the rubber
cap
•Remove the tube.
Note: Note: Note: Note: Note:
Handle the hydraulic oiI very carefully. It
is corrosive, and will irreparably damage
painted or plastic parts of the motorcycle
upon contact.
52