Beta REV-3 Manual Del Usuario página 65

4
GB
ADJUSTMENT OF BRAKES ADJUSTMENT OF BRAKES ADJUSTMENT OF BRAKES
ADJUSTMENT OF BRAKES ADJUSTMENT OF BRAKES
F F F F F ront brake ront brake ront brake ront brake
ront brake
The front brake is disk type with hydraulic
control, and therefore requires only ordi-
nary maintenance. If you want to adjust
the position of the lever, use register A A A A A .
R R R R R ear brake ear brake ear brake ear brake
ear brake
The rear brake is disk type with hydraulic
control. You may adjust pedal height by
means of registers B B B B B and C C C C C .
A minimum
reccommended.
ADJUSTMENT OF CL ADJUSTMENT OF CL ADJUSTMENT OF CLUT ADJUSTMENT OF CL ADJUSTMENT OF CL
Generally, the only operation that is
performed on the clutch is adjustment of
the position of lever E E E E E . . . . . To do this, use
register D D D D D . . . . .
Note: Note: Note: Note: Note:
The device you push clutch must have a
play of between 0.4 mm and 0.6 mm.
Therefore, proceed as follows when re-
placing disks:
•Reassemble the clutch without the outer
cover
•Send the control rod to end of travel by
pushing from the pressure plate and
measure distance F F F F F
•Operate the clutch lever until the control
rod activates the pressure plate. Measure
distance G G G G G and check that there is
difference of approximately 0.4-0.6mm.
64
of clearance
UTCH UT UT UT CH CH CH CH
is